Elektromotor Fernsteuerung Programmierbox QUICRUN / SEAKING

Ban 500 V3 RTS
\n\nHere is the V3 version of the best -selling fishing people Boat!
\n
\n This boat now has tilted drop -off hatches ensuring faster and effective release of baits
\n
\n Characteristics: \n

• Length: 556mm \n
• Width: 240mm \n
• Height: 230mm \n
• Mass: 1650g \n
• Quantity of primers per drop: 500g maxi \n
• Speed: 1m/s \n
• Powered by 2 chaperal engines \n
• 5000MAH battery supplied with its charger \n
• Low battery alert by flashing the boat\'s lights \n
• Radio 2.4GHz for a liaison without risk of interference \n
• Large of primers piloted from the remote control \n
• New tilting dropping hatches \n
• Magnetic hooks to take your lines at a long distance \n
• Blue and red lighting for night use! \n
• Catamaran type shell for great stability and very low water \n
• Transport bag offered! \n
  \n

Detailed functions:
\n
\n\n 1) Speed ​​in straight line: 1m/s
\n 2) Boarding radius (right and left): 1.5m (Note: the direction is ensured by the speed differential between the two propellers)
\n 3) Speed ​​in reverse: about 0.15m/s
\n 4) Continuous maximum speed autonomy: about 20 minutes
\n 5) Navigation lights: 2 blue headlights are located at the front, 2 red lights are located at the rear. A switch located on the receiver inside the shell. When the switch is in position on, the navigation lights remain lit continuously.
\n 6) Low battery alert: When the boat\'s battery is close to the minimum voltage, the navigation lights start to flash. Indicating to the fisherman that it is time to recharge the battery.
\n Note: 6.1) Once the low battery alert is activated, the boat has about 4 minutes of autonomy. 6.2) Whether the navigation lights are activated or not, they will start to flash when the battery voltage will reach the minium voltage threshold corresponding to the activation of the alert.
\n 7) Largage hatch: Close the hatch before pouring the primers in the compartment. The button located on the transmitter controls the opening of the hatch. Pressing the button, the hatch opens entirely and all the primers are released. The hatch will remain open during the rest of the navigation.
\n 8) Magnetic hooks: It is possible to connect 2 lines to the back of the boat, they are retained by magnetization. The boat allows you to drop the lines wherever you want. Once at the desired location, just pull the line to detach it from the magnet and thus release it. Bring the boat back to the bank, close the hatch, fill it again with primers, then connect a new line and finally place it where you want and so on for all your lines.\n